Comp-cams 912 Honda D16 Valve Springs Manuel d'utilisateur télécharger pdf

COMP Cams®

3406 Democrat Rd.

Memphis, TN 38118

Phone: (901) 795-2400 Fax: (901) 366-1807

www.compcams.com

Part #COMP4-105

Revised 6/28/06

#912 Honda D16 Valve Springs

Thank you for choosing COMP Cams® products; we are proud to be your manufacturer of choice.

Please read this instruction sheet carefully before beginning installation, and also take a moment to

review the included limited warranty information.

The Honda D-Series SOHC VTEC valve spring set utilizes a single spring on the intake side and a

single spring on the exhaust side. Below are the information and diagram to ensure correct installation.

Warnings and maintenance information! *It is important to orientate the valve spring with the tightly

wound coils on the bottom.

*Note: To figure out which end is the tightly wound end, start at the end of the coil, follow it

around 180°, then look at the distance between the two coils. Follow the same steps from the

other end of the spring, whichever end is closest together needs to be on the bottom.

INSTRUCTIONS

Installation Instructions

Installed Height: 50 lbs at 1.950

Open Height: 170 lbs at 1.450

Coil Bind Height: 1.360

Spring Rate: 240 lbs per inch

1 2

COMP Cams® 3406 Democrat Rd. Memphis, TN 38118 Phone: (901) 795-2400 Fax: (901) 366-1807 www.compcams.com Part #COMP4-105 Revised 6/28/06

Page 2

COMP Cams® 3406 Democrat Rd. Memphis, TN 38118 Phone: (901) 795-2400 Fax: (901) 366-1807 www.compcams.com Part #COMP4-105 Revised 6/28/06 Limited Wa

Pas de commentaire

Comp-cams 912 Honda D16 Valve Springs Manuel d'utilisateur